TViP S-BOX

Plug everything in and start the box
1. Set the box’s language and time zone, and connect it to the network so the internet is connected.
2. Go to TV in the left menu and change all settings so that it looks like this:
* Stream Source: Multicast
* UDPXY Server:
* MPEG-TS Buffering, msec: 5000
* DVR Storage: No storage
* Timeshift storage: Internal storage
* Auto-timeshifting: Off
* Content Source: Web Portal

Below Content Source: Web Portal is a button that says Setup Web portal. Press it and set the following settings: Portal URL: You will receive this from us when we have added your box to our system.

Portal Manager: Off
Use Web portal: Whole System
API Mode: GSTB

Then press Apply. Then everything is ready. Now you just need to buy an account from us and state your MAC address in your order, and we will connect it to our system for you.

If you have to factory reset your box, then do it like this

if you have a newer box, it is the FN button

1. Press s.info/FN, 4, 9, s.info/FN on the controller, then select ok.
2. Wait until the box has been reset.
3. Set language and time zone.
4. Then press the gear wheel and select TV.
5. Then you go down to “Content Source” and select “Web Portal”.
6. Then press “Setup Web portal” which you will find at the bottom. There you must fill in so that it looks as shown below.

Portal URL: You get it from us in support
Portal manager: Off
Use Web portal: Whole system
API mode: GSTB